MY FIRST TUTORIAL

Hi again!!!  I'm very excited because this is my first tutorial.  I will show how to make a candy bar card, to put a name to it.  I had to prepare this tutorial for SCRAPBOOKING GALICIA, where I'm the Guest Designer for St. Valentine's Day.  Yeyyyy!!!

Here is what you need to do:

You will need a piece of cardstock of 8" by 11".  On the 8" side score at:

3½", 3-3/4", 4", 7½" and 7-3/4".

On the 11" side, please score at:

7" and 7¼" 

Cut the below rectangle that measures 3½" x 4" and cut the above rectangle that measures ½" x 7", and do a little cut where there are the other two scores.  I know it sounds complicated but it isn't.  See the photos below for a better reference.

 

Closer look:

 Make all the folds, except the one shown on the photo (the one that it is on 3-3/4"):
 

Closer look:

Glue as show with a strong adhesive.

To make the flower you will need:

Tissue Tape (I used one from Tim Holtz)
10" of ribbon (it has to be a little bit wider than the tissue tape)
Needle and thread

Glue the tissue tape to the ribbon.

Make a simple thread through all the ribbon's length.

Pull the thread and roll the ribbon.

Tie the two ends of thread to close the flower.  Embellish as you like (I put a flower button on the center).

Here is my finished project:

Inside:

For instructions in Spanish go HERE.

The image is a LOV stamp coloured with Distress Ink and the ticket sentiments are from Paper Cupcakes.